Sign Sign Logo
Magnetic Sign Care and Use
Aluminum Signs
Button 2
Button 3
Button 4
Security Signs
Button 6 Window Signs Home Page

Magnetic Sign Links:

General Information
Car, Van & Truck Signs
Industrial Magnetic Signs
Magnetic Bumper Signs
Postal Delivery Signs
Driver Education Signs
Magnetic Sign Care
Sign Quality
Request a Quote / Layout
Order Magnetic Signs

Other Sign Types

Contact Us
About Us

Phone Numbers

Kastwell Logo

Credit Cards Accepted

Related Sites:

Applying Magnetic SignsMagnetic Sign Care and Use Instructions

  • Make sure the entire magnet is flat against the metal surface. Do not place over protrusions (molding,decals, pin striping, etc.) or concave areas. There must be NO air pockets.

  • The magnet itself should be at a room temperature of 60°F (16°C) or above when installed to achieve best results.

  • Do not apply magnet that has been curled with the magnet side out. The magnet may not attach properly to the metallic surface resulting in lifted corners or air gaps which will weaken its holding strength. Follow instructions for Storing Flexible Magnet.

  • If you place the magnet in the wrong position, completely remove the magnet from the surface and re affix. Lift at sides and not at corners to remove. Do not pull the magnet sign across the surface, or it may stretch due to the resistance caused by the high magnetic strength.

  • Do NOT use on horizontal metal surfaces exposed to direct sunlight (such as automobile hoods), temperatures exceeding 160ºF (71ºC) or temperatures below -15ºF (-26ºC). Exposure to cold weather will make the magnet more brittle so use caution when handling.

  • Be aware that long-term use on surfaces frequently exposed to sunlight (such as vehicles) can result in uneven fading of the surface because the magnet-covered area is shielded from ultraviolet rays.

  • Do NOT use magnetic signs on non-metallic body fillers, simulated wood grain siding and repainted surfaces.
    NOTE: Doors and panels on some vehicles are not made of steel. Magnetic signs will not work on aluminum and plastic surfaces.

  • Before placing magnetic sign on a vehicle, be sure all surface paints, clear coats and waxes are cured (hardened). (Approximate curing times: paint—90 days; clear coat—60 days; wax—2 days.)

  • Clean the vehicle surface and the magnet with mild detergent.

  • Wipe with a soft cloth or allow to dry

  • To guard against moisture and dirt buildup between the magnet and the metal surface
    (particularly on outdoor applications), remove the magnet at regular intervals. Clean
    both the magnet and metal surface with mild detergent; wipe with a soft cloth or allow to air-dry. (For vehicle-mounted signs, remove and clean weekly.)

    After waxing and polishing vehicle, allow 2 days for wax to cure before applying magnets.

Storing Signs
  • When not using signs, keep signs in a clean, dry place.
  • Store rolled signs on end to keep it from developing flat spots
  • Store rolled signs on end with the printed or vinyl side out. No tighter than 4 inch diameter roll
  • Stack flat magnetic signs on a level surface. Avoid placing objects (such as cartons) on top that could damage the face; do not stack with magnetic sides facing each other.